ITENDEESPTRU

Hardware modification for transmit audio

The only modification V6 needs: UV-K5 V3 and UV-K1

What it is for

To receive, no modification is needed: the stock radio is fine for all the decoders.

This modification brings the audio generated by the radio (DAC output) to the transmitter. You only need it for:

  • Parrot: sending the recorded voice on the air
  • Repeater: VOICE mode
  • Sig Report: the spoken sentence
  • Rattlegram: transmitting from the radio
  • SSTV: optional, for the AUDIO DAC MOD mode (without it, it transmits with AUDIO CHIP)
Before you startThe components are very small: you need a magnifier and a fine-tip soldering iron. If you are not experienced, have someone who is do it. The work is at your own risk.

UV-K5 V3

Fit these components at the points shown in the photo:

  • integrated circuit: 74LVC1G3157GW
  • three capacitors: 100 nF
  • resistor: 1 k
UV-K5 V3
The modification on the UV-K5 V3.

UV-K1

Fit these components at the points shown in the photo:

  • integrated circuit: 74LVC1G3157GW (SOT363)
  • three capacitors: 100 nF
  • resistor: 1 k
UV-K1
The modification on the UV-K1.

If you don't have the integrated circuit

Warning: Larsen effectWithout the integrated circuit it can be done with a wire jumper, a 1 k resistor and a 100 nF capacitor. It works, but it can cause Larsen effect problems with the microphone. If you can, fit the version with the integrated circuit.
UV-K1
UV-K1 without the integrated circuit: wire, 1 k and 100 nF.
UV-K5 V3
UV-K5 V3 without the integrated circuit: wire and the two circled components. The X marks what is not fitted.